Switchport Vlan Translation Default Drop - Allied Telesis x310-26FT Command Reference Manual

VLAN C
OMMANDS

SWITCHPORT VLAN TRANSLATION DEFAULT DROP

switchport vlan translation default drop
Overview Use this command to configure a default behavior of dropping inbound tagged
packets that have a VLAN-ID that does not match any entries in the VLAN
translation table for an interface.
Use the no variant of this command to stop dropping non-matching inbound
packets and let them be accepted as is for further processing.
switchport vlan translation default drop
Syntax
no switchport vlan translation default drop
Default Do not drop packets
Mode Interface Configuration for a switch port or a static channel group, or a dynamic
(LACP) channel group. The interface must be in a mode that supports tagged
packets.
Example To drop inbound tagged packets arriving at port1.0.1 unless they match a VLAN
translation entry, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To accept inbound tagged packets arriving at port1.0.1 regardless of whether they
match a VLAN translation entry, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show interface switchport vlan translation
Commands
switchport vlan translation default drop
C613-50103-01 REV A
configure terminal
interface port1.0.1
switchport vlan translation default drop
configure terminal
interface port1.0.1
no switchport vlan translation default drop
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
514