Platform Hwfilter-Size - Allied Telesis x310-26FT Command Reference Manual

S C
WITCHING OMMANDS
-
PLATFORM HWFILTER SIZE

platform hwfilter-size

Overview You can use this command to control the configuration of hardware Access
Control Lists (ACLs), which determines the total available number and
functionality of hardware ACLs.
For this command to take effect, you need to reboot the affected service.
One cannot attach an IPv6 ACL to a port if the ACL contains a specified source or
destination IPv6 address or both and the hw-filter size setting is
ipv4-limited-ipv6. If you do so, a diagnostic message will be generated.
platform hwfilter-size {ipv4-limited-ipv6|ipv4-full-ipv6}
Syntax
Default The default mode is ipv4-limited-ipv6.
Mode Global Configuration
Example To configure hardware ACLs to filter IPv4 and IPv6 traffic, use the following
commands:
awplus#
awplus(config)#
Related show platform
Commands
ipv6 access-list (named)
C613-50103-01 REV A
Parameter
hwfilter-size
ipv4-full-ipv6
ipv4-limited-ipv6
configure terminal
platform hwfilter-size ipv4-full-ipv6
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Configure hardware ACLs command.
Configure hardware ACLs to filter IPv4 traffic, MAC
addresses and IPv6 traffic, including filtering on source or
destination IPv6 addresses, or both; however, this will
reduce the total number of filters available in the hardware
table.
Configure hardware ACLs to filter IPv4 traffic, MAC
addresses and IPv6 traffic. Source or destination IPv6
addresses or both are not filtered.
447