Switchport Port-Security Aging - Allied Telesis x310-26FT Command Reference Manual

S C
WITCHING OMMANDS
-
SWITCHPORT PORT SECURITY AGING

switchport port-security aging

Overview Use this command to set MAC addresses that have been learned by port security
to age out.
Use the no variant of this command to set the MAC addresses to not age out.
Syntax switchport port-security aging
no switchport port-security aging
Mode Interface Configuration
Examples To set port1.0.4 so that the MAC addresses that have been learned by port security
age out, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To stop the MAC addresses that have been learned by port security from aging out
on port1.0.4, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related clear port-security intrusion
Commands
show port-security interface
show port-security intrusion
switchport port-security
switchport port-security maximum
switchport port-security violation
C613-50103-01 REV A
configure terminal
interface port1.0.4
switchport port-security aging
configure terminal
interface port1.0.4
no switchport port-security aging
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
476