Table of Contents
Advertisement
VLAN C
OMMANDS
-
SWITCHPORT MODE PRIVATE
VLAN TRUNK PROMISCUOUS
switchport mode private-vlan trunk
promiscuous
Overview
Use this command to enable a port in trunk mode to be promiscuous port for
isolated VLANs.
Use the no variant of this command to remove a port in trunk mode as a
promiscuous port for isolated VLANs. You must first remove the secondary port, or
ports, in trunk mode associated with the promiscuous port with the no switchport
mode private-vlan trunk secondary command.
switchport mode private-vlan trunk promiscuous group <group-id>
Syntax
no switchport mode private-vlan trunk promiscuous
Default
By default, a port in trunk mode is disabled as a promiscuous port.
Mode
Interface Configuration
Usage
A port must be put in trunk mode with
can be enabled as a promiscuous port.
To add VLANs to be trunked over the promiscuous port, use the
allowed vlan
To configure the native VLAN for the promiscuous port, use the
native vlan
VLAN.
When you enable a promiscuous port, all of the secondary port VLANs associated
with the promiscuous port via the group ID number must be added to the
promiscuous port. In other words, the set of VLANs on the promiscuous port must
be a superset of all the VLANs on the secondary ports within the group.
C613-50103-01 REV A
Parameter
<group-id>
command. These VLANs can be isolated VLANs, or non-private VLANs.
command. The native VLAN can be an isolated VLAN, or a non-private
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The group ID is a numeric value in the range 1 to 32 that is
used to associate the promiscuous port with secondary ports.
switchport mode trunk
command before it
switchport trunk
switchport trunk
502
Advertisement
Table of Contents
