Epsr Mode Master Controlvlan Primary Port - Allied Telesis x310-26FT Command Reference Manual

E P S
THERNET ROTECTION WITCHED

EPSR MODE MASTER CONTROLVLAN PRIMARY PORT

epsr mode master controlvlan primary port
Overview This command creates a master EPSR instance.
NOTE
This command creates a master EPSR instance. Your switch is unable to run this
command because it cannot function as an EPSR master node. To include these
switches in an EPSR ring you will need to use an alternative Allied Telesis switch,
such as an x610 Series switch, as the master node. For more information on this
command, refer to the manual of your master EPSR node's switch.
epsr <epsr-instance> mode master controlvlan <2-4094>
Syntax
primaryport <port>
NOTE
The software allows you to configure more than two ports or static channel groups to
the control VLAN within a single switch or stacked node. However, we advise against
this because in certain situations it can produce unpredictable results.
Mode EPSR Configuration
To create a master EPSR instance called blue with vlan2 as the control VLAN and
Example
port1.0.1 as the primary port, use the command:
awplus(config-epsr)#
primaryport port1.0.1
Related epsr mode transit controlvlan
Commands
show epsr
C613-50103-01 REV A
R (EPSR ™) C
ING ING OMMANDS
: Running your switch as an EPSR master node requires a feature license.
Parameter
<epsr-instance>
mode
master
controlvlan
<2-4094>
primaryport
<port>
:
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Name of the EPSR instance.
Determines the node is acting as a master.
Sets switch to be the master node for the named EPSR ring.
The VLAN that will transmit EPSR control frames.
VLAN id.
Primary port for the EPSR instance.
The primary port. The port may be a switch port (e.g.
port1.0.4) or a static channel group (e.g. sa2). It cannot
be a dynamic (LACP) channel group.
epsr blue mode master controlvlan vlan2
2002