Show Epsr Config-Check - Allied Telesis x310-26FT Command Reference Manual

E P S
THERNET ROTECTION WITCHED
-
SHOW EPSR CONFIG CHECK

show epsr config-check

Overview This command checks the configuration of a specified EPSR instance, or all EPSR
instances.
If an instance is enabled, this command will check for the following errors or
warnings:
•
•
•
•
•
show epsr [<instance>] config-check
Syntax
Mode User Exec and Privileged Exec
Example To check the configuration of all EPSR instances and display the results, use the
command:
awplus#
Table 49-1: Example output from show epsr config-check
EPSR Status
Instance
----------------------------------------------------------------------------
red Warning
device is stacked.
white OK.
blue Warning
orange OK.

Don't forget to check that this node's configuration is consistant with all
other nodes in the ring.
----------------------------------------------------------------------------
Related show epsr
Commands
C613-50103-01 REV A
R (EPSR ™) C
ING ING OMMANDS
The control VLAN has the wrong number of ports.
There are no data VLANs.
Some of the data VLANs are not assigned to the ring ports.
The failover time is less than 5 seconds for a stacked device.
The instance is a master with its secondary port on a common segment.
Parameter Description
<instance>
Name of the EPSR instance to check on.
show epsr config-check
Description
Failover time is 2s but should be 5s because
Primary port is not in data VLANs 29-99.
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
2014