12.6.6
Center heater lamp / Side heater lamp (LAMP1/LAMP2)
(1)
Take off the fuser roller unit.
P.12-14 "12.6.2 Pressure roller unit /
Fuser roller unit"
(2)
Remove 2 screws on each terminal of both
center heater lamp and side heater lamp.
(3)
Pull out the center heater lamp and side
heater lamp.
Notes:
•
When installing the heater lamps, be sure
not to mix up the upper heater lamp and
the lower heater lamp.
The upper heater lamp has a coil wound
up on its center part, and the lower heater
lamp has coils wound up on its both
edges.
•
When installing the heater lamps, be sure
to face up their weld sides.
•
Do not touch the lamps directly with your
hands.
•
The connector on each end of the
harness which connects to the center
heater lamp has a small screw hole. The
connector on each end of the harness
which connects to the side heater lamp
has a big one.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 12-25
Center heater lamp
Fig. 12-26
Upper side : center heater lamp
Lower side : side heater lamp
Weld
Fig. 12-27
12 - 19
Side heater lamp
e-STUDIO182/212/242
FUSER / EXIT UNIT
12