Debug Uplink-State-Group - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10.0.2
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
8.3.19.0
8.3.12.0
8.4.2.3
Related Commands
•
•

debug uplink-state-group

Enable debug messages for events related to a specified uplink-state group or all groups.
Syntax debug uplink-state-group [group-id]
To turn off debugging event messages, enter the no debug uplink-state-group [group-id]
command.
Parameters
group-id
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10.0.2
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
9.2(0.0)
1618 Uplink Failure Detection (UFD)
Description
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
downstream — assigns a port or port-channel to the uplink-state group as a downstream interface.
uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
Enables debugging on the specified uplink-state group. The valid group-id values are from
1 to 16.
Description
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.