Gestetner G060 Service Manual page 590

COPY SP MODE
017
[DF Magnification Adj.] DF Magnification Adjustment
1 DF Magnification Adj.
110 [Punch Position]
1 Punch 1
2 Punch 2
[Staple Position]
111
1 Staple Position
[Multi Bin Set]
901
1 Multi Bin Set
G570
* Adjusts the magnification in the sub-scan direction
NV
for the ARDF.
[ -5.0 to 5.0 / 0 / 0.1 %/step ]
* Adjusts the punching position.
BCU
Punch 1
US: 2 punch holes
Europe: 2 punch holes
North Europe: 4 punch holes
Punch 2
US: 3 punch holes
Europe: 4 punch holes
Increment: Holes move toward the paper center.
Decrement: Holes move toward the paper edge.
[ -7.5 to 7.5 / 0 / 0.5 mm/step ]
* Adjusts the stapling position.
BCU
Increment: Staple position moves toward the edge
of paper.
Decrement: Staple position moves toward the
center of paper.
[ -3.5 to 3.5 / 0 / 0.5 mm/step ]
NOTE: Although the adjustable range is ±3.5 mm,
the stapling position can be changed only by 1.0
mm when stapling one position at the front or rear
side even when the input value is more than 1.0.
* Specifies whether or not the optional multi-bin
BCU
output tray is installed. When installing the multi-
bin output tray, this SP mode should be set to "1".
[ 0 or 1 / 0 / - ]
0: Not installed
1: Installed
5-52 SM