Gestetner G060 Service Manual page 748

BIT SWITCHES
Scanner Switch 0B
No FUNCTION
0-3 Scan margin setting (right and left margin in book scan ADF mode)
The setting can be between 0 and F (H) (unit 0.5 mm).
Default setting: 2 mm
4-7 Scan margin setting (top and bottom margin in book scan and ADF mode)
The setting can be between 0 and 7 (H) (unit 0.5 mm).
Default setting: 3 mm
Scanner Switch 0C
No FUNCTION
0 Action when an original jam
has occurred while scanning
the original into memory for
memory tx
0: Continues scanning after
recovery
1: Stops scanning and erases
all scanned pages for that job
1 Setting when an original size
to cannot be recognized
2 Bit 2 1 Setting
0 0 No original
0 1 A5
1 0 A5
1 1 No original
3-5 Not used
6 Scan width used for a
document set in the ADF when
the width is less than 230 mm.
0: A4 (210 mm)
1: LT (216 mm)
7 Not used
G307
This bit is only effective when parallel memory tx is
disabled (user parameter 07 - bit 2).
If parallel memory tx is enabled, the machine always
erases the scanned pages when an original jam
occurs. The machine then asks the user to retry
from the first page, even if the parallel memory tx is
not actually used.
0: The machine displays a message asking the user
1: The machine erases all the scanned pages and

Do not change the settings.
This bit is set at "1" when the country code is set to
the US.
Do not change the settings.
COMMENTS
COMMENTS
to put the jammed page back into the original
stack, and continues scanning.
The message is displayed for the time period
specified by scanner switch 0E, bit 2.
asks the user to retry from the first page.
3-24
SP No. 1-102-012
SP No. 1-102-013
SM