Gestetner G060 Service Manual page 1080

Firmware History for G060
DESCRIPTION OF MODIFICATION
Fusing clutch control has been added to
start/stop the clutch.
The following has been corrected:
When a paper jam occurs midway through a
staple job, job recovery may re-start the job
from the 1st page instead.
Over-occurrence of the following SC codes
(due to software bugs) has been fixed:
SC220/230 at the start of a job.
SC544/554 during warm-up under low-temp
conditions in 62.5mm/sec mode.
SP1-916 (Idling mode) has been added.
916 [Idling Mode]
1 Mode Set
2 Idling Time
3 Pre-Job Mode
To optimize the amount of oil supplied to the
fusing belt in OHP mode, the number of
supply cycles during idling has been
reduced to 1.
SP1-996-6 (OHP Pre-Job mode) has been
added.
996 [OHP/TH Fusing]
6 Pre-Job Mode
NOTE 2 – Engine main firmware version B1.17C was applied to the production line on February
18th, 2002, and most machines with Ver. B1.15E have been reworked locally: However, some of
these machines have been released to the market without modification. Therefore please update
the engine firmware to ver B1.17C or newer on G060-17 machines in the following serial number
range: P60112xxxxx – P60201xxxxx.
FIRMWARE
LEVEL
G0775621 A
* Enables or disables fusing unit idling performed after the machine
reaches the Ready condition. Idling is performed for the time
specified in SP1-916-2.
[0 or 1/ 0 / -] DFU
0: OFF, 1: ON
Specifies the time for fusing unit idling.
[10 to 120 / 30 / 10 sec/step] DFU
Enables or disables the 4-second fusing unit idling performed at
the start of a print job.
[0 or 1/ 0 / -] DFU
0: OFF, 1: ON
G0775623
* Enables or disables the 30-second fusing unit idling performed at
the start of an OHP print job. When enabled, idling is performed
even if the machine is at the Ready condition.
[0 or 1/ 0 / -]
0: OFF, 1: ON
SERIAL FIRMWARE
NUMBER VERSION
December B1.15E
2001
March B1.17C
2002
(See Note
2)
Continued Next Page
Page 3 of 16
CHECK
SUM
171C
169B