Gestetner G060 Service Manual page 142

SC TABLE
SC No. Item
SC 734 Finisher tray 2 Tray 2 home position is not
shift motor detected within a specified
error time after the tray 2 shift motor
turns on.
SC 818 Watch-dog While the system program is
error running, other processes do
not operate at all.
SC 819 Fatal error
[696E] Process error System completely down
[766D] Memory error Unexpected system memory
size
G060
Definition Possible Cause
• Loose connection
• Defective tray shift 2
sensor
• Defective tray 2 shift
motor
• Defective controller
• Software error
• Defective RAM DIMM
• Defective ROM DIMM
• Defective controller
• Software error
4-28
Related
Troubleshooting Procedure
SCs
1. Turn the main switch off and on.
2. Check if the connectors of the sensor
and motor are properly connected.
3. Replace the tray shift 2 sensor.
4. Replace the tray 2 shift motor.
1. Turn the main switch off and on.
2. Replace the controller.
3. See NOTE 1 at the end of the SC
table
1. Turn the main switch off and on.
2. Check and/or replace the RAM DIMM.
3. Check and/or replace the ROM
DIMM.
4. Replace the controller.
5. See NOTE at the end of the SC
table.
Rev. 09/2003
Type
CTL
CTL
SM