Gestetner G060 Service Manual page 702

[A]
7. Remove the rear left cover plate [A] and install the fax unit [B] (2 screws each).
NOTE: Make sure that the controller unit is installed when inserting the fax
unit. If the controller unit is installed after the fax unit has been
installed, this may cause poor connection between the fax unit and
controller unit.
8. Connect the cable to the LINE2 jack, then plug in the machine and turn the
main switch on.
9. Attach the FCC/IC approval label to the machine near the ISDN jack (this step
is only for US/Canada).
10. Enter the service mode and set bit 1 of communication switch 16 to "1", then
turn the main switch off and on.
11. Print the system parameter list and ensure that "SG3-V34" is listed as an
option.
12. Set up and program the items required for PSTN-2 communications.
G307
[B]
1-6
FAX UNIT OPTIONS
G307I101.WMF
SM