Gestetner G060 Service Manual page 914

Tech Service Bulletin No. G060 –011
Page 2 of 3
1. Make sure the machine's main power switch is turned off.
2. Open the front cover.
3. Turn the release lever of the Paper Transfer Belt Unit counterclockwise and pull out the Transfer Belt
Unit. Place a sheet of paper underneath the Transfer Belt Cleaning Unit to catch any toner that may fall
out. Next, remove the cleaning unit (1 screw).
NOTE:
Also remove the Duplex Unit if installed (1 screw).
4. Remove the paper transfer unit (lock bracket, 1 screw) and place it onto a few sheets of clean paper.
NOTE:
If the paper transfer unit is placed onto a dirty surface, foreign particles may get onto the
transfer belt and cause damage to the OPC drums.
5. Remove the following parts from the unit.
•
[A] High voltage wire NOTE: When re-securing the wire, make sure to angle it down as
shown in the illustration. This will prevent it from touching the PCUs.
•
[B] Wire contact
•
[C] Transfer entrance guide
•
[D] Tension springs
NOTE: Be careful that the springs do not pop out when removing or reinstalling.
[A]
Tech Service Bulletin No. G060/G570 – 011
Page 3 of 3
Cushion Installation Procedure
[D]
[C]
[B]
Continued...