Gestetner G060 Service Manual page 199

Mode No.
5
(Class 1, 2, and 3)
[Memory Clear 1]
801
1 All
2 ENG All
3 SCS
4 IMH
5 MCS
8 PRT
11 NCS
802 EngineFreeRun
1 EngineFreeRun
803 [Input Check]
804 [Output Check]
808 [Destination] Destination Code Display
1 Destination
[SC ON/OFF] SC Detection ON/OFF
809
1 SC ON/OFF
810 [SC Reset]
1 SC Reset
811 [SN Display] Serial Number Display
2 SN Display
[FAX TEL No.]
812
2 FAX TEL No.
832 [HDD Init.] HDD Initialization
1 HDD Init.
SM
PRINTER ENGINE SERVICE MODE
Function / [ Setting ]
P Resets all the controller and engine settings to
their defaults and the counters to 0.
To clear the memory, enter this SP mode, press
the Enter key, then turn the main switch off and
on.
NOTE: All settings are reset to the defaults. SMC
sheets should be printed out before doing
a memory clear.
See NOTE 1 at the end of the SP table for a list of
settings cleared.
Clears all the engine settings and counters.
Engine settings and engine counters can be
cleared independently with SP5-998-001 and 002.
P Clears the system settings.
P Not used.
P
P Clears the user mode system settings.
P Clears the network settings.
P Performs a free run on the printer engine.
NOTE:
•
The machine starts free run in the same
condition as the sequence of A4/LT printing
from the 1st tray. Therefore, paper should be
loaded in the 1st tray, but paper is not fed.
•
The main switch has to be turned off and on
after using the free run mode for a test.
See section 5-3-2.
See section 5-3-3.
* Displays the destination code.
* Enable or disables the service call detection (SC
codes will be ignored if disabling this SP mode).
[ 0 or 1 / 0 / - ] Alphanumeric
0: Enable
1: Disable
* Resets a type A service call condition.
NOTE: Turn the main switch off and on after
resetting the SC code.
* Displays the machine serial number.
* Sets the fax or telephone number for a service
P representative. This number is printed on the
Counter List, which can be printed with the user's
"Counter" menu if the Meter Charge mode is
selected with SP5-930-1.
This can be up to 13 characters (both numbers
and alphabetic characters can be input).
P Initializes the hard disk. Use this SP mode only in
there is a hard disk error.
5-31 G060