Others; Front Plate; Grounding Spring; Drive Gear And Left Drive Roller - Gestetner G060 Service Manual

TRANSFER AND PAPER TRANSPORT UNIT

3.7.5 OTHERS

Front Plate

Normally, you do not have to remove the front plate [A]. If, however, the front plate
is removed, make sure that projections [B] fit in the screw holes [C] when
reassembling. If not, the transfer belt moves to the rear or front end.
[A]
[B]
[C]
[D]
G060R817.WMF

Grounding Spring

When reassembling the transfer unit, make sure that the grounding spring [D] is in
the correct position. If the spring is out of position and not in contact with the front
plate, high voltage leak may occur, causing a malfunction.

Drive Gear and Left Drive Roller

[D] [E]
[B]
[C]
[A]
G060R820.WMF
Normally, you do not have to remove the drive gear [A], the left drive roller [B], and
the timing belt [C]. If, however, any of these is removed, make sure that the drive
gear mark [D] and the left drive roller mark [E] are positioned at the top when
reassembling. If the gear and roller are not positioned as shown, this may cause
the transfer belt speed to fluctuate slightly, resulting in color shifts.
SM 3-27 G060