Gestetner G060 Service Manual page 1004

SC TABLE
SC 851 IEEE1394
interface error
SC 860 HDD:
Initialization error
SC 861 HDD: Reboot
error
SC 863 HDD: Read error
SC 864 HDD: CRC error
SC 865 HDD: Access
error
SC 900 Electric counter
error
SC 990 Software
performance
error
G570
• Defective IEEE1394
The 1394 interface is
unusable. • Defective controller.
The controller detects that • HDD not initialized
the hard disk fails.
• Defective HDD
The HDD does not become • Loose connection
ready within 30 seconds • Defective cables
after the power is supplied
• Defective HDD
to the HDD.
• Defective controller
The data stored in the HDD • Defective HDD
cannot be read correctly. • Defective controller
While reading data from the • Defective HDD
HDD or storing data in the
HDD, data transmission
fails.
An error is detected while • Defective HDD
operating the HDD.
• Defective NVRAM
Abnormal data is stored in
the counters.
• Defective controller
• Defective software
The software makes an
unexpected operation. • Defective controller
• Software error
1. Turn the main switch off and on.
2. Replace the IEEE1394 interface
board.
3. Replace the controller.
1. Turn the main switch off and on.
2. Reformat the HDD.
3. Replace the HDD.
1. Turn the main switch off and on.
2. Check the connection between the
HDD and controller.
3. Check and replace the cables.
4. Replace the HDD.
5. Replace the controller.
1. Turn the main switch off and on.
2. Replace the HDD.
3. Replace the controller.
1. Turn the main switch off and on.
2. Replace the HDD.
1. Turn the main switch off and on.
2. Replace the HDD.
1. Turn the main switch off and on.
2. Check the connection between the
NVRAM and controller.
3. Replace the NVRAM.
4. Replace the controller.
1. Turn the main switch off and on.
2. Reinstall the controller and/or engine
main firmware.
3. See NOTE 1 at the end of the SC
table.
4-42
Rev. 09/2003
B
B
B
B
B
B
B
B
SM