Gestetner G060 Service Manual page 928

FIRMWARE HISTORY
DESCRIPTION OF MODIFICATION
Fusing clutch control has been added to
!
start/stop the clutch.
The following has been corrected:
When a paper jam occurs midway through a
!
staple job, job recovery may re-start the job
from the 1st page instead.
Over-occurrence of the following SC codes
!
(due to software bugs) has been fixed:
SC220/230 at the start of a job.
!
SC544/554 during warm-up under low-temp
!
conditions in 62.5mm/sec mode.
SP1-916 (Idling mode) has been added.
!
916 [Idling Mode]
1 Mode Set
2 Idling Time
3 Pre-Job Mode
To optimize the amount of oil supplied to the
!
fusing belt in OHP mode, the number of
supply cycles during idling has been
reduced to 1.
SP1-996-6 (OHP Pre-Job mode) has been
!
added.
996 [OHP/TH Fusing]
6 Pre-Job Mode
NOTE 2 – Engine main firmware version B1.17C was applied to the production line on February
18th, 2002, and most machines with Ver. B1.15E have been reworked locally: However, some of
these machines have been released to the market without modification. Therefore please update
the engine firmware to ver B1.17C or newer on G060-17 machines in the following serial number
range: P60112xxxxx – P60201xxxxx.
G060
FIRMWARE
G0775621 A
* Enables or disables fusing unit idling performed after the machine
reaches the Ready condition. Idling is performed for the time
specified in SP1-916-2.
[0 or 1/ 0 / -] DFU
0: OFF, 1: ON
Specifies the time for fusing unit idling.
[10 to 120 / 30 / 10 sec/step] DFU
Enables or disables the 4-second fusing unit idling performed at
the start of a print job.
[0 or 1/ 0 / -] DFU
0: OFF, 1: ON
G0775623
* Enables or disables the 30-second fusing unit idling performed at
the start of an OHP print job. When enabled, idling is performed
even if the machine is at the Ready condition.
[0 or 1/ 0 / -]
0: OFF, 1: ON
14-2
SERIAL
LEVEL NUMBER
December
2001
March
2002
(See Note 2)
Rev. 10/2002
FIRMWARE
VERSION
B1.15E
B1.17C
Continued Next Page
SM