Energy Saver Mode - Gestetner G060 Service Manual

FUSING

6.8.7 ENERGY SAVER MODE

When the machine is not being used, the energy saver feature reduces power
consumption by switching off the fusing lamp. This machine has two energy saver
modes.
Level 1 Energy Saver Mode
The default for level 1 energy saver mode is disabled. If the user enables it, energy
saver level 1 mode starts 30 seconds after the machine has completed a print. In
this mode, the fusing lamps are intermittently turned on and off to keep the heating
roller at 100°C and pressure roller at 130°C.
The machine leaves this mode when one of the following happens.
• Print command received from the PC
• Any cover opened and closed
• Any operation panel keys pressed
Level 2 Energy Saver Mode
Level 2 energy saver mode starts after the machine has been idle for a certain
time. This time is specified by a user tool. During level 2 energy saver mode, both
lamps switch off.
• Off (energy saver mode never activates)
• 5 minutes
• 15 minutes
• 30 minutes
• 45 minutes
• 60 minutes (default)
When the machine is in this mode, the machine turns off +24V, +12V, and +5V
lines. However, only +5VE lines, for the controller and GAPCI (voltage monitoring
ASIC) on the BCU, are still active.
The machine leaves energy saver mode when one of the following happens.
• Print command received from the PC
• Any operation panel keys pressed
NOTE: The machine does not leave level 2 energy saver mode when covers are
opened and closed, because the CPU on the BCU is not active.
G060 6-60 SM