Gestetner G060 Service Manual page 858

FIRMWARE UPDATE PROCEDURE
5.4.4 FIRMWARE UPGRADE
!
CAUTION
1. Open the front cover whenever updating the firmware.
2. Do not turn off the machine while downloading the firmware.
Upgrading Printer Firmware
To upgrade the firmware, you must connect the printer to your PC with an Ethernet
cross-over cable. There are two methods:
1) Using Fiery WebTool:
2) Using the lpr command: Sends the files by using a command line
NOTE: In this section, "Web browser" indicates "Internet Explorer 5.0 or later," or
"Netscape 4.5 or later."
Using Fiery WebTools
Preparation on the printer
1. Turn the main switch on.
2. Wait until "Ready" is displayed.
3. Print out the Configuration Page.
4. Connect the printer and PC with an Ethernet cross-over cable.
5. Select the menu "Network Protocol Setup."
6. Select the submenu "TCP/IP-Ethernet," and change the setting from "No" to
"Yes."
7. Select the submenu "Eth. IP Address," and input an IP address. (e.g.
133.139.157.101)
8. Select the submenu "Eth. Subnet Mask," and input an address mask. (e.g.
255.255.255.0)
9. Select the submenu "Gateway Address," and input a gateway address. (e.g.
133.139.157.001)
10. Select the submenu "Enable AppleTalk," and change the setting from "Yes" to
"No."
11. Press the Cancel key. The system reboots automatically.
12. Open the front cover.
G082
Sends the files by using a Web browser
5-6
Ready
G082S910.WMF
SM