Gestetner G060 Service Manual page 860

FIRMWARE UPDATE PROCEDURE
Updating using the lpr Command
Preparation on the printer
1. Turn the main switch on.
2. Wait until "Ready" is displayed.
3. Print out Configuration Page in case you need
to refer to the current settings.
4. Connect the printer and the PC with an Ethernet cross cable.
5. Select the menu "Network Protocol Setup."
6. Select the submenu "TCP/IP-Ethernet," and change the setting from "No" to
"Yes."
7. Select the submenu "Eth. IP Address," and input an IP address. (e.g.
133.139.157.101)
8. Select the submenu "Eth. Subnet Mask," and input an address mask. (e.g.
255.255.255.0)
9. Select the submenu "Gateway Address," and input a gateway address. (e.g.
133.139.157.001)
10. Select the submenu "Enable AppleTalk," and change the setting from "Yes" to
"No."
11. Press the Cancel key. The system reboots automatically.
12. Open the front cover.
Preparation on the PC
1. Set the TCP/IP address for your PC. (e.g. 133.139.157.010)
NOTE: Do not use the IP address of the printer.
2. Set the Subnet Mask (e.g. 255.255.255.0).
3. Reboot the PC.
Upgrade Procedure
1. Check that the printer front cover is open.
2. Use the Run command in the Windows Start Menu.
3. Transfer the firmware to the printer by using the lpr command.
(e.g. lpr -S 133.139.157.101 -P xjdirect "Firmware File Name")
NOTE: In the example, "Firmware File Name" indicates the file name of the
firmware. The IP address is the address of the printer set in Step 7 of
"Preparation on the printer"
G082
Ready
5-8
G082S910.WMF
SM