Gestetner G060 Service Manual page 692

ORIGINAL TRANSPORT AND EXIT
4.5.2 DOUBLE-SIDED ORIGINALS
[B]
Shortly after the transport motor has been
turned on, the inverter solenoid is activated
and junction gate [A] opens. The original is
then scanned and transported towards the
reverse table [B].
[A]
G564D105.WMF
[E]
Shortly after the original exit sensor [C]
detects the trailing edge of the original, the
inverter solenoid turns off and the junction
gate [D] closes.
Next, the inverter motor turns on and the
inverter roller [E] starts rotating to feed the
original from the reverse table.
[C]
G564D107.WMF
[D]
Then the original is fed to the transport roller
and the scanning area [F] (where the
reverse side is scanned).
[F]
G564D106.WMF
After scanning the reverse side of the
[G]
original, the original is then sent to the
reverse table [G] a second time and turned
over. This ensures that the double-sided
original will be properly stacked in the correct
order, front side down, in the original exit tray
[H]
[H].
G564D108.WMF
G564 8-22 SM