Gestetner G060 Service Manual page 889

Tech Service Bulletin No. G060 – 004
Page 2 of 3
Duplex Unit:
•
Do not lift the printer by the inverter unit (left side of the machine).
Paper Supply Units:
•
When transporting the machine with the Paper Supply Unit installed:
•
Make sure the lock plate is properly installed.
•
Make sure there is no paper left in the paper trays and fix down the bottom plates with a sheet of paper
and tape.
•
Attach shipping tape to the trays or shrink-wrap the printer and paper supply unit tightly.
•
Do not hold the printer up by the handles. This is because the lock plate joins the printer to the paper
supply unit only on the right rear corner. Lifting the printer up by the handles can cause damage to the
lock plate.
Finisher:
This finisher contains a very precise but delicate drive mechanism for the tray. Therefore, the following
procedure should be followed when transporting the Finisher.
When transporting the finisher from floor to floor:
1. Remove the output trays from the finisher to prevent stress or damage.
When transporting the finisher (used for demonstration or show) by truck:
1. The finisher should be repacked in the carton, i.e. returned to the same condition as when it first arrived
from the factory.
Continued...