G060R801.WMF
[K]
12. Two tension springs [K][L]
CAUTION: Be careful that the springs do not jump out when removing or
reinstalling.
13. Unhook the gear [M] (1 spacer, 1 bushing)
14. Raise the actuator [N] and remove the roller-holder plate [O] ( x 1, 1 bushing)
NOTE: The front and rear roller-holder plates are greased. Do not touch the
grease. If the grease has been wiped off, apply grease G-501 or Barrierta
S552R to the same place.
15. Transfer belt roller [P] ( x 1, 1 bushing, 1 gear)
Reassembly
Set the left end of the spring.
Pull the transfer belt roller to the
right.
Set the right end of the spring.
Check that the spring is straight.
Press the front end of the gear
shaft to properly set the gear on the
shaft.
SM
TRANSFER AND PAPER TRANSPORT UNIT
[N]
[O]
3-25
[M]
[L]
[P]
OK
NG
G060R814.WMF
G060