Gestetner G060 Service Manual page 204

PRINTER ENGINE SERVICE MODE
5
(Class 1, 2, and 3)
993 22 Interrupt 1
23 Interrupt 2
24 Mscan Lgth Det
994 [Unit Set] Maintenance Unit Detection ON/OFF
1 Dev/PCU
2 Oil Unit
997 [Test Pattern]
1 Tray Selection
G060
Mode No.
#
#
Function / [ Setting ]
* Specifies the number of sheets to be printed
before a line position adjustment is done during a
print job.
[ 10 to 250 / 100 / 10 sheets/step ]
SP 5-993-4 must be set to 'enabled'.
When the temperature difference meets the
conditions specified in SP5-993-3, the machine
starts counting the number of prints in the job. The
machine interrupts the print job and does the line
position adjustment if the number of prints
exceeds the number specified in this SP mode.
If the counted number of prints does not exceed
the number specified, the machine resets the
counter, then continues to monitor the
temperature and does the line position adjustment
next time.
* Performs the line position adjustment when the
number of prints reaches the number specified in
this SP mode regardless of the temperature
change.
[ 0 to 350 / 200 / 50 prints/step ]
0: Disable
* Performs the main scan length detection when the
polygon motor has operated consecutively for the
time specified in this SP mode.
[ 100 to 990 / 200 / 50 s/step ]
* Enables or disables PCU and development unit
detection.
[ 0 or 1 / 0 / - ] Alphanumeric
0: Enable
1: Disable
NOTE: If this mode is disabled, new unit detection
also does not function. Use this mode as a
temporary measure, only when the micro-
switches are defective.
* This is for the oil supply unit only, and not the
fusing unit
[ 0 or 1 / 0 / - ] Alphanumeric
0: Enable
1: Disable
NOTE: Use this mode as a temporary measure,
only when the unit detection mechanism is
defective.
Selects the tray for making a test print.
[ 0 to 4 / 1 / 1/step ]
0: By-pass Table
2: Tray 2
4: Tray 4
NOTE: The machine makes a test pattern on the
paper size loaded in the selected paper
tray.
5-36
1: Tray 1
3: Tray 3
SM