Accessing The Required Program; Inputting A Value Or Setting For A Service Program; Exiting Service Mode - Gestetner G060 Service Manual

SERVICE PROGRAM MODE

Accessing the Required Program

Use the "Up/Down arrow" keys to scroll through the menu listing.
1. Service Menu: Controller service modes
2. Engine Mainte: Engine service modes
3: End: Exit service mode
To select an item, press the "Enter" key. Then the sub-menu will appear.
Scroll through the sub menu items using the "Up/Down arrow" keys.
To go back to a higher level, press the "Escape" key.

Inputting a Value or Setting for a Service Program

Enter the required program mode as explained above. The setting appearing on
the display is the current setting.
Select the required setting using the "Up/Down arrow" keys, then press the "Enter"
key. The previous value remains if the "Enter" key is not pressed.

Exiting Service Mode

Select "3. End" from the service mode main menu, then press the "Enter" key.
NOTE: To make the following settings effective, you must turn the main switch off
and on after exiting service mode.
SP Modes Related to the Engine
SP2-208-009
SP2-213-001
SP2-224-001 to 004
SP5-930-001 to 005
SP5-994-001 and 002
SP7-905-007 and 009
NOTE: If the settings of SP modes 5-993-013 to 015 are changed, these changes
will affect the next line position adjustment.
G060
SP Modes Related to the Controller
SP5-009-001
SP5-961-001
5-2 SM