System, Copy Application, Netfile Application Firmware - Gestetner G060 Service Manual

Firmware History for G570

1. SYSTEM, COPY APPLICATION, NETFILE APPLICATION FIRMWARE

System
P/N
Version
G5705388B 1.02
G5705388C 1.05
G5706688 1.07
Check
Contents of Modification
Sum
- Firmware from the first mass production run.
•
-
Letterhead Mode has been added (See
TSB G060/G570 - 019 for details).
•
Date and time display format for Asia has
been changed to that of Europe.
•
SP7-904 [Print: Printer Gamma] deleted.
•
SP7-807 [SC Jam Counter Clear] added.
•
The following has been fixed:
♦
The staple LED on the operation
panel does not light at staple end
condition.
•
0CC4
The meter click counter specification has
been changed so that copies made in SP
mode are not counted up. With this
modification, SC999 is detected when
updating the engine main firmware from
ver1.15E or older to 1.07 or later (see TSB
G060/G570 - 018 for details).
•
A grid pattern has been added to SP
mode copy images. To activate this, it is
necessary to use system firmware ver1.07
or newer.
•
Specification changed so that the red LED
for the printer application key top lights up
when an alert condition is detected (e.g.
fusing/oil supply unit near end). Just as
with the G060 printer, the LED lighting
conditions depend on the setting of SP5-
930-3.
•
RMS is supported with the use of the
customized controller (field monitoring
machines only).
•
The following have been fixed:
♦
The Punch Counter counts up by 2 for
every sheet punched when using the
function in Duplex Mode.
♦
Executing system settings reset does
not clear the password settings for
stored documents or change the
setting for Auto-off (energy saver 2)
back to default.
♦
Printed sheets are fed out to shift tray
2 of the finisher in punch/staple mode.
♦
Centering problem when printing onto
12" x 18" paper.
Production
December,
2001
January,
2002
March, 2002
Page 2 of 11