Gestetner G060 Service Manual page 465

6. Hook the right end of the
wire onto the front scanner
wire bracket [I], with the
end going via the front
track of the right pulley [J]
and the front track of the
movable pulley [K].
NOTE: Do not secure the
scanner wire bracket
with the screw yet.
7. Remove the tape from the
drive pulley.
8. Insert a scanner positioning
pin [L] through the 2nd
carriage hole [M] and the left
holes [N] in the front rail.
Insert another scanner
positioning pin [O] through
the 1st carriage hole [P] and
the right holes in the front rail
[Q].
9. Insert two more scanner
positioning pins in the holes
in the rear rail.
10. Screw the drive pulley to the shaft [R].
11. Screw the scanner wire bracket to the front rail [S].
12. Install the scanner wire clamp [T].
13. Pull out the positioning pins.
NOTE: After removing the positioning pins, make sure the 1st and 2nd carriages
move smoothly. If they do not, repeat steps 8 through 13.
SM
[K]
[O]
[L]
[M]
[N]
3-17
REPLACEMENT
[I]
G570R116.WMF
[J]
[T]
[P]
G570R117.WMF
[Q]
G570
[R]
[S]