Mode No.
1
(Class 1, 2, and 3)
[OHP/TH Fusing] OHP/Thick Paper Fusing Temperature Correction
996
( H eating or P ressure Roller)
Specifies the temperature for starting a print job.
The fusing section is already warmed up when the last print job was completed. If prints
are made on OHP or thick paper at this time, the fusing temperature tends to be higher
than the target, causing exit roller marks or a paper jam in the fusing section.
To prevent this, the print job will not start if the heating and pressure roller temperatures
are higher than the following:
(Target temperature specified by SP1-105-12, -13, -23, -24) - (Temperature specified by
this SP mode (default: 5°C for heating roller, 10°C for pressure roller))
4
H:Print Temp
5
P:Print Temp
SM
Function / [ Setting ]
*
[ 0 to 20 / 5 / 1°C /step ]
BCU
[ 0 to 20 / 10 / 1°C /step ]
5-15
COPY SP MODE
G570