Gestetner G060 Service Manual page 520

SC TABLE
SC 818 Watch-dog error
SC 819
[696E] Process error
[766D] Memory error
SC820
[0001] CPU error
to
[06FF]
[0702] CPU/Memory
Error
[0709]
[070A]
G570
• •
While the system program is • Defective controller
running, other processes do • Software error
not operate at all.
• Defective RAM DIMM
System completely down
• Defective ROM DIMM
Unexpected system memory
size • Defective controller
• Software error
Self-diagnostics error: CPU
During the self-diagnostic, • System firmware
the controller CPU detects
an error. There are 47 types • Defective controller
of error code (0001 to 4005)
depending on the cause of
the error. The CPU detects
an error and displays the
specific error code with the
program address where the
error occurs).
• System firmware
• Defective RAM-DIMM
• Defective controller
Fatal error
[XXXX]: Detailed error code
problem
problem
4-38
7.
1. Turn the main switch off and on.
2. Replace the controller.
3. See NOTE 1 at the end of the SC
table.
1. Turn the main switch off and on.
2. Check and/or replace the RAM DIMM.
3. Check and/or replace the ROM
DIMM.
4. Replace the controller.
5. See NOTE at the end of the SC
table.
1. Turn the main switch off and on.
2. Reinstall the controller system
firmware.
3. Replace the controller.
When the problem cannot be fixed with
the above procedure, the following
information displayed on the screen
needs to be fed back to a technical
support center.
• SC code
• Detailed error code
• Program address
1. Turn the main switch off and on.
2. Reinstall the controller system
software.
3. Replace the RAM-DIMM.
4. Replace the controller.
Rev. 09/2003
B
B
B
B
SM