Gestetner G060 Service Manual page 476

PRINTER ENGINE
3.5.2 BCU
NOTE: 1) After replacing the BCU, remove the NVRAM on the old board and
install it on the new board.
2) A DIP switch setting is required, if the new board has a DIP switch.
( Following page - DIP Switch Settings)
1. Option bracket [A] ( x 2)
2. Rear cover [B] ( x 4)
3. Cover bracket [C] ( x 3)
4. Inner bracket [D] ( x 2)
5. Connector cover [E] ( x 1)
6. BCU [F] ( x 8, x 23)
NOTE: After replacing the BCU, remove the
NVRAM on the old board and install it
on the new board. If the NVRAM on
the old board is defective, replace the
NVRAM ( 3.1.10 NVRAM
Replacement Procedure).
G570 3-28
[A]
[B]
G060R701.WMF
[C]
[D]
G060R702.WMF
G060R703.WMF
SM
[E]
[F]