Gestetner G060 Service Manual page 581

Mode No.
5
(Class 1, 2, and 3)
828 39 Apple Talk Type
40 Working Zone: AT
47 Job Analysis Timeout
48 Job Timeout
49 Noise Cancel
50 1284 Compatibility
51 Data Transfer
52 ECP
53 Transmission Speed
831 [Initial Setting Clear]
1 Initial Setting Clear
[HDD Init.] HDD Initialization
832
1 All
2 IMF
3 NFA
4 Job Log
5 Printer Fonts
9 Debug
[JobLog ON/OFF]
833
7 JobLog ON/OFF
SM
Function / [ Setting ]
* Sets the AppleTalk type for the network.
CTL
Sets the AppleTalk working zone for the network.
Sets the Centronics job analysis timeout for the
network.
[ 0 to 4200 / 3 / 1 sec/step ]
Sets the Centronics job timeout for the network.
[ 0 to 4200 / 0 / 1 sec/step ]
Sets the noise cancel level for the network.
[ 4 to 7 / 4 / 1 clock/step ]
Switches Centronics IEEE1284 compatibility on/off
for the network.
[ 0 or 1 / 1 / - ]
0: Disabled, 1: Enabled
Selecting "0" disables bi-directional data
transmission.
Sets the Centronics transfer speed for the
network.
[ 0 or 1 / 1 / - ]
0: Slow, 1: Fast
If you select "0" there will be a 120 µs delay from
the STP signal to the data transfer. (With 1: Fast
there is no delay.)
Switches the ECP setting for Centronics off/on.
[ 0 or 1 / 1 / - ]
0: Disabled, 1: Enabled
With "1" selected, SP5-828-050 must be enabled
for 1284 mode compatibility .
Selects the Ethernet transmission speed.
[ 0 to 3 / 0 / 1 /step]
0: Auto
1: 10Base-T
2: 100Base-TX
3: Auto
Clears the system settings, except for the timer
and user code settings.
# Initializes the hard disk (the entire disk, or by
partitions). Use this SP mode only when there is a
hard disk error.
DFU
* Saves the result of the jobs in the job log. If this
CTL
mode is enabled, the result is written on the HDD.
If no HDD is installed, this feature is disabled even
if this SP is set to 'enabled'.
[ 0 or 1 / 0 / - ]
0: Disabled
1: Enabled
5-43
COPY SP MODE
G570