Gestetner G060 Service Manual page 480

OTHERS
⇒
6. Install the CF Expander into the G060 mainframe.
NOTE: Note: Do not turn the main power on at this time. If it is turned on
SC672/990 will be displayed but will not affect the update.
7. Upgrade to the G060 firmware as follows.
Firmware needed:
CF NIB, Scanner Application, Fax Application
Follow the five steps below (in roman numerals) and upgrade the CF NIB,
Scanner Application, and Fax Application. After all three are completed,
continue with step 7.
I. Make sure the main power switch is OFF.
II. Remove the IC card cover [D].
III. Fully insert the IC card [E] containing the required firmware into the
IC card slot on the controller.
IV. Turn the main power ON. The upgrade will begin automatically.
V. After the firmware update is completed, "Update done" or "Power Off
On" will be displayed. Turn OFF the main power and remove the IC
card.
8. Turn controller board DIP SW 1 OFF.
NOTE: Please do not turn the main power on at this time. If it is turned on
characters on the panel will appear garbled, but this will not affect the
update.
9. Upgrade to the G570 LCD firmware (Operation Panel).
NOTE: During the LCD firmware update, the Operation Panel will not function.
The Start Key will flash RED. Do not power off unit the Start Key flashes
GREEN.
I. Make sure that the main switch is OFF.
II. Fully insert the IC card containing the Operation Panel firmware
into the IC card slot on the controller.
G570
[D]
[E]
3-32
Rev. 07/2003
SM