Gestetner G060 Service Manual page 579

Mode No.
5
(Class 1, 2, and 3)
[Memory Clear 1]
801
1 All module
2 ENG All
3 SCS / SRM
5 MCS
6 Copy Memory Clr?
7 Fax
8 Printer application
9 Scanner application
10 Network application
11 NCS
12 IPU
13 R-FAX
[Engine Free Run]
802
1 Engine Free Run
[Input Check]
803
804 [Output Check]
808 [Destination] Destination Code Display
1 Destination
[SC Detection ON/OFF]
809
1 SC ON/OFF
[SC Reset]
810
1 SC Reset
[Machine Serial No.] Machine Serial Number Display
811
2 Serial Number Display
[FAX TEL No.]
812
1 Telephone
SM
Function / [ Setting ]
# Resets all the controller and engine settings to
their defaults and the counters to 0. DFU
Clears all the engine settings and counters. DFU
Initializes the system settings.
Not used.
Initializes the copy application settings.
Initializes the fax application settings.
Initializes the printer application settings.
Initializes the scanner application settings.
Deletes the network file application management
files and thumbnails, and initializes the job login
ID.
Initializes the system defaults and interface
settings (IP addresses also), SmartNetMonitor for
Admin, WebStatusMonitor settings, and the
TELNET settings.
Clears the IPU settings
Initializes the job login ID, SmartNetMonitor for
Admin, job history, and local storage file numbers.
Performs a free run on the printer engine.
NOTE:
•
The machine starts free run in the same
condition as the sequence of A4/LT printing
from the 1st tray. Therefore, paper should be
loaded in the 1st tray, but paper is not fed.
•
The main switch has to be turned off and on
after using the free run mode for a test.
See section 5-4-2.
See section 5-4-3.
*BCU Displays the destination code.
*BCU Enable or disables the service call detection (SC
codes will be ignored if disabling this SP mode).
[ 0 or 1 / 0 / - ] Alphanumeric
0: Enable
1: Disable
*BCU Resets a type A service call condition.
NOTE: Turn the main switch off and on after
resetting the SC code.
*BCU Displays the machine serial number.
* Sets the telephone number for a service
CTL representative. This number is printed on the
Counter List, which can be printed with the user's
"Counter" menu.
This can be up to 20 characters (both numbers
and alphabetic characters can be input).
5-41
COPY SP MODE
G570