Gestetner G060 Service Manual page 859

Preparation on the PC
1. Set the TCP/IP address for your PC (e.g. 133.139.157.010).
NOTE: Do not use the IP address of the printer.
2. Set the Subnet Mask (e.g. 255.255.255.0).
3. Reboot the PC.
Upgrade Procedure
1. Check that the printer front cover is open.
2. Run the Web browser.
3. Type the printer IP address into the Web browser to run Fiery WebTools.
NOTE: The printer IP address is the address you have input in the submenu
"Eth. IP Address."
4. Click the "Web Downloader" button of Fiery WebTool.
5. Click the "Print Connection" button, and select the following option:
0: Direct Connection
6. Browse through the source file list to where you downloaded the firmware file
previously, and select the firmware.
7. Click the "Send file" button.
8. Wait until the "Data In" LED blinks.
9. Check that the massages "Upgrading System"
and "Do Not Power Off" are displayed.
NOTE: Do NOT turn the main switch off
before the messages disappear.
10. Wait until the "Data In" LED goes out. The
printer reboots automatically.
11. Close the front cover when "Close Front Cover" is displayed.
NOTE: Fiery WebTools does not output any message or indication at the end
of firmware upgrading. Quit Fiery WebTools by clicking the close button
(x) after "Ready" is displayed on the printer display.
12. Check the firmware version by printing Configuration Page.
13. Return all printer settings that were changed in order to perform the upgrade
back to their original values.
SM
FIRMWARE UPDATE PROCEDURE
Upgrading System
Do Not Power Off
5-7
G082S912.WMF
G082