Gestetner G060 Service Manual page 518

SC TABLE
SC No. Item
SC 731 Finisher exit
guide plate motor
error
SC 732 Finisher tray 1
shift motor error
SC 733 Finisher tray 2 lift
motor error
SC 734 Finisher tray 2
shift motor error
G570
Definition
• Loose connection
The exit guide plate open
• Defective exit guide
sensor is not activated
within a specified time after
• Defective exit guide
the exit guide plate motor
turns on.
• Loose connection
Tray 1 home position is not
• Defective tray shift 1
detected within a specified
time after the tray 1 shift
• Defective tray 1 shift
motor turns on.
• The lower stack height 1 • Loose connection
• Defective lower stack
sensor is activated
consecutively (detecting
• Defective tray 2 lift
paper) for 15 seconds
after the shift tray starts
• Motor overload
moving up.
• The lower stack height
sensor 1 is deactivated
consecutively (not
detecting paper) for 15
seconds after the shift
tray starts moving down.
• Loose connection
Tray 2 home position is not
• Defective tray shift 2
detected within a specified
time after the tray 2 shift
• Defective tray 2 shift
motor turns on.
Related
Possible Cause
SCs
plate open sensor
plate motor
sensor
motor
height 1 sensor
motor
sensor
motor
4-36
Troubleshooting Procedure
1. Turn the main switch off and on.
2. Check if the connectors of the sensor
and motor are properly connected.
3. Replace the exit guide plate open
sensor.
4. Replace the exit guide plate motor.
1. Turn the main switch off and on.
2. Check if the connectors of the sensor
and motor are properly connected.
3. Replace the tray shift 1 sensor.
4. Replace the tray 1 shift motor.
1. Turn the main switch off and on.
2. Check if the connectors of the sensor
and motor are properly connected.
3. Replace the lower stack height 1
sensor.
4. Replace the tray 2 lift motor.
1. Turn the main switch off and on.
2. Check if the connectors of the sensor
and motor are properly connected.
3. Replace the tray shift 2 sensor.
4. Replace the tray 2 shift motor.
Type
B
B
B
B
SM