Gestetner G060 Service Manual page 896

BULLETIN NUMBER: BULLETIN NUMBER: BULLETIN NUMBER: BULLETIN NUMBER:
APPLICABLE MODEL: : : : APPLICABLE MODEL APPLICABLE MODEL APPLICABLE MODEL
GESTETNER – DSC38 GESTETNER – DSC38 GESTETNER – DSC38 GESTETNER – DSC38
RICOH – AP3800C RICOH – AP3800C RICOH – AP3800C RICOH – AP3800C
SAVIN – SLP38C SAVIN – SLP38C
SAVIN – SLP38C SAVIN – SLP38C
SUBJECT: INSTALLATION NOTES - COPIER FEATURE EXPANDER
Shipping Configuration - Pre-configured Model:
Rack
Refer to the G060/G570
Service Manual G570
section, Page 1-9 for setup
instructions
Special installation Instructions are
included with pre-configured printers.
If the printer has not been pre-
configured, (the copier feature
expander and the printer were
purchased separately) please refer to
the G060 Service Manual, G570
section, Page 1-13, for installation
instructions.
To identify if the printer was pre-configured to support the copier feature expander, remove the
controller and note the following:
Controller preconfigured to support the copier feature expander
IPU Board, NVRAM Board, DIMM 1
(SYSTEM), DIMM 2 (PRT/SCN), and Hard
Drive have already been installed.
Controller, which was not pre-configured to support the copier feature expander
IPU Board, NVRAM Board, DIMM 1
(SYSTEM), DIMM 2 (PRT/SCN) have not
been installed
* This DIMM is removed and replaced with DIMM 1 (SYSTEM) and DIMM 2 (PRT/SCN) when configured to
support the Copier Feature Expander
   
Copyright 2002 RICOH Corporation. All rights reserved.
TECHNICAL SERVICE BULLETIN TECHNICAL SERVICE BULLETIN TECHNICAL SERVICE BULLETIN TECHNICAL SERVICE BULLETIN
G060 - 007 G060 - G060 - G060 - 007 007 007 04/03/2002 04/03/2002 04/03/2002 04/03/2002
Copier Feature Expander
Scanner Unit
G060 Printer
* Duplex Unit
* 500x1 Paper Bank
* Main Switch Cover
* IPU Board
* NVRAM Board
* DIMM #1 (SYSTEM)
* DIMM #2 (PRT/SCN)
* 40 GB HDD
* Already Installed
IPU Board is installed
Only one *Postscript DIMM
CONTROL NO. 076CLR
Continued...