Gestetner G060 Service Manual page 144

SC TABLE
SC No. Item
SC822 Self-diagnostic error: HDD (Hard Disk Drive)
[3003] Timeout error When the main switch is
turned on or starting the self-
[3004] Command
diagnostic, the HDD stays
error
busy for the specified time or
more.
SC 823 Self-diagnostic error: NIB
[6101] MAC address The result of the MAC address
check sum check sum does not match the
error check sum stored in ROM.
[6104] PHY IC error The PHY IC on the controller
cannot be properly recognized.
[6105] PHY IC loop- An error occurred during the
back error loop-back test for the PHY IC
on the controller.
SC 824 Self-diagnosis The controller cannot
error: recognize the standard
[1401]
Standard NVRAM installed or detects
NVRAM that the NVRAM is defective.
SC 827 Self-diagnostic error: Standard SRAM DIMM
[0201] Verification Error detected during a
error write/verify check for the
standard RAM (SRAM DIMM).
G060
Definition Possible Cause
[XXXX]: Detailed error code
• Loose connection
• Defective HDD
• Defective controller
[XXXX]: Detailed error code
• Defective controller
• Loose connection
• Defective standard
NVRAM
• Defective controller
[XXXX]: Detailed error code
• Loose connection
• Defective SRAM
DIMM
• Defective controller
4-30
Related
Troubleshooting Procedure
SCs
1. Turn the main switch off and on.
2. Check that the HDD is properly
connected to the controller.
3. Replace the HDD.
4. Replace the controller.
1. Turn the main switch off and on.
2. Replace the controller.
1. Turn the main switch off and on.
2. Check the standard NVRAM is firmly
inserted into the socket.
3. Replace the NVRAM.
Replace the controller.
1. Turn the main switch off and on.
2. Replace the SRAM DIMM.
3. Replace the controller.
Rev. 09/2003
Type
CTL
CTL
CTL
CTL
SM