Gestetner G060 Service Manual page 589

SP6-XXX (Peripherals)
Mode No.
6
(Class 1, 2, and 3)
[DF Registration Adj.] DF Registration Adjustment
006
1 Side-to-Side
2 Leading Edge
3 Buckle: Duplex Front
4 Buckle: Duplex Rear
5 Rear Edge Erase
[ADF Input Check]
007
1 Group 1
2 Group 2
008 [ADF Output Check]
1 Fee-in Motor Fwd.
2 Feed-in Motor Rev.
3 Drive Motor Fwd.
4 Reverse Motor Fwd.
5 Reverse Motor Rev.
6 Feed Clutch
7 Inverter Solenoid
8 Pick-up Motor Fwd.
9 Pick-up Motor Rev.
[DF Free Run]
009
1 Duplex Mode
2 Stamp Mode
010 [Stamp Position Adj.] Fax Stamp Position Adjustment
1 Stamp Position Adj.
[Original Size Priority] Original Size Detection Priority
016
1 Original Size Priority
SM
Function / [ Setting ]
* Adjusts the side-to-side and leading registration of
originals with the ARDF.
NV
[ -30 to 30 / 0 / 0.1 mm/step ]
Adjusts the amount of paper buckle to correct
original skew for the front and rear sides.
[ -4.2 to 4.2 / 0 / 0.1 mm/step ]
Adjusts the erase margin at the original trailing
edge.
[ -20 to 10 / 0 / 0.5 mm/step ]
Displays the signals received from the sensors
and switches of the ARDF. (See 5.4.2)
Activates the electrical components for functional
check.
It is not possible to activate more than one
component at the same time.
Performs a DF free run in duplex mode or stamp
mode.
* Adjusts the horizontal position of the stamp on the
NV
scanned originals.
[ -3.5 to 3.5 / 0 / 0.5 mm/step ]
* Specifies the original size for a size detected by
NV the original sensor, since original sensors cannot
recognize all sizes.
[ 0 or 1 / 0 / - ]
0: Setting 1
1: Setting 2
Setting 1
Bit 7 A4 (L)
Bit 6 11"x15"
Bit 5 DLT (L)
Bit 4 LT (S)
Bit 3 LT (L)
Bit 2 LG (L)
Bit 1 A4 (L)
Bit 0 8K (L)
Bits used for detection differ depending on
destination as shown below.
Bit 7 to 6: Only for Japan
Bit 5 to 2: Only for US
Bit 1 to 0: Only for EU/AA
5-51
COPY SP MODE
Setting 2
LT (L)
DLT (L)
11"x15"
US Exec (S)
8"x10" (L)
F4 (L)
16K (L)
DLT (L)
G570