Gestetner G060 Service Manual page 895

Tech Service Bulletin No. G060 – 006
Page 2 of 2
SOLUTION:
PRODUCTION COUNTERMEASURE:
The temperature at which the display changes to "Ready" has been lowered by 1°C. This has been applied
from engine firmware version B1.17C.
NOTE: The actual operating temperature has not been changed, only the display trigger temperature.
FIELD COUNTERMEASURE:
Update the engine firmware to version B1.17C or newer on G060-17 machines if the serial number is
between P60112xxxxx - P60201xxxxx and the engine firmware is ver B1.15E.
NOTE: If the CF expander is installed, "Energy Saver 1 Mode" will automatically be activated (the default
changes to ON), therefore please make sure this update is performed.
NOTE: The firmware can be downloaded through the Technology Solution Center FTP Site
http://tsc.ricohcorp.com. Refer to Facts Line Bulletin # FL002 and Publication Bulletin #023 for
more information about the FTP Internet Web Site and EPROM / Flash Card Exchange program.
ENGINE FIRMWARE VERSION CONFIRMATION PROCEDURE:
1. See Figure 1 for key locations.
2. Press the Menu Key.
3. Press the Down Arrow and scroll to
"list / test print".
4. Press the Enter Key
"Config." Page is displayed.
5. Press enter again to print the
Configuration Page.
6. Check the Configuration Page as
illustrated in Figure 2.
Figure 2
Menu Key
Figure 1
Engine Firmware
is B1.17C
Down Arrow
Enter Key
B1.17C:30