Gestetner G060 Service Manual page 769

G3 Switch 0A
2-3
Not used
4
Maximum allowable frame
interval during image data
reception.
0: 5 s 1: 13 s
5 Not used
6 Reconstruction time for the first
line in receive mode
0: 6 s 1: 12 s
7
Not used
G3 Switch 0B
No FUNCTION
0
Protocol requirements: Europe
0: Disabled 1: Enabled
1 Protocol requirements: Spain
0: Disabled 1: Enabled
2 Protocol requirements:
Germany
0: Disabled 1: Enabled
3
Protocol requirements: France
0: Disabled 1: Enabled
4 PTT requirements: Germany
0: Disabled 1: Enabled
5
PTT requirements: France
0: Disabled 1: Enabled
6
Not used
7
DTS requirements : Germany
0: Disabled 1: Enabled
G3 Switch 0C
No FUNCTION
0 Pulse dialing method
1 Bit 1 Bit 0 Setting
0 0 Normal(P=N)
0 1 Oslo (P=10 - N)
1 0 Sweden
(N+1)
1 1 Not used
2-7
Not used
SM
Do not change the settings.
This bit set the maximum interval between EOL
(end-of-line) signals and the maximum interval
between ECM frames from the other end.
Try using a longer setting if error code 0-21 is
frequent.
Do not change the settings.
When the sending terminal is controlled by a
computer, there may be a delay in receiving page
data after the local machine accepts set-up data and
sends CFR. This is outside the T.30
recommendation. But, if this delay occurs, set this
bit to 1 to give the sending machine more time to
send data.
Refer to error code 0-20.
ITU-T T.30 recommendation: The first line should
come within 5 s of CFR.
Do not change the settings.
COMMENTS
The machine does not automatically reset these bits
for each country after a country code (System
Switch 0F) is programmed.
Change the required bits manually at installation.
Do not change the settings.
Change this bit manually if required.
COMMENTS
P = Number of pulses sent out, N = Number dialed.
Do not change the settings.
3-45
BIT SWITCHES
SP No. 1-105-011
SP No. 1-105-012
SP No. 1-105-013
G307