Gestetner G060 Service Manual page 567

Mode No.
3
(Class 1, 2, and 3)
125 4 ACC
[Forced Self-check] Forced Self-check
126
1 Forced Self-check
2 Forced TD Adj.
902 [Pointer Display] Pointer Table Display ([Color])
1 Printer [K]
2 Printer [Y]
3 Printer [M]
4 Printer [C]
5 CF [K]
6 CF [Y]
7 CF [M]
8 CF [C]
[M/A Target] M/A Target ([Color])
903
Adjusts the M/A ( M ass per A rea, mg/cm
check.
Adjusting this changes the development bias. This causes the solid ID to increase or
decrease. If developer capability causes an ID problem, toner density needs to be
adjusted with SP3-120-1 to 4, depending on the color.
1 Printer [K]
2 Printer [Y]
3 Printer [M]
4 Printer [C]
5 CF [K]
6 CF [Y]
7 CF [M]
8 CF [C]
[M/A for LD] M/A Target for LD Correction ([Color])
904
Adjusts the M/A value used during the LD correction mode. This value is effective when
SP3-125-2 "LD Control Selection" is set to "2".
Adjusting this data effects the image reproduction especially in highlight areas.
1 Printer [K]
2 Printer [Y]
3 Printer [M]
4 Printer [C]
5 CF [K]
6 CF [Y]
7 CF [M]
8 CF [C]
SM
Function / [ Setting ]
* Enables or disables the process control self-check
BCU before printing the ACC pattern.
[ 0 to 2 / 2 / 1/step ] Alphanumeric
0: Disable
1: Process Control
2: Auto TD Adj. (& Process Control Self-check)
NOTE:
If color balance changes during multi-copy runs
after ACC is performed, select 1 or 2. Setting 2
can precisely adjust the image density; however, it
takes about 6 minutes. Select 1 or 2 depending on
the customer's requirement.
Performs a forced process control self-check.
Performs a forced auto toner density adjustment.
Do not use unless advised by senior technical
staff.
* Displays the number in the pointer table that was
BCU selected during the latest process control self-
check.
[ 1 to 30 / - / 1/step ]
2
) value used during the process control self-
* [ 0 to 1.50 / 0.50 / 0.05 mg/cm
BCU
[ 0 to 1.50 / 0.60 / 0.01 mg/cm
[ 0 to 1.00 / 0.10 / 0.01 mg/cm2 /step] DFU
*
BCU [ 0 to 1.00 / 0.12 / 0.01 mg/cm2 /step] DFU
[ 0 to 1.00 / 0.13 / 0.01 mg/cm2 /step] DFU
[ 0 to 1.00 / 0.14 / 0.01 mg/cm2 /step] DFU
5-29
COPY SP MODE
2
/step ] DFU
2
/step ] DFU
G570