Gestetner G060 Service Manual page 729

2
Mode No.
103 G3-1 NCU Parameters
001 – 023 CC, 01 – 22
104 G3-2 NCU Parameters
001 – 023 CC, 01 – 22
SP3-XXX (Tel Line Settings)
3
Mode No.
101 Service Station
001 Fax Number
002 Select Line
102 Serial Number
000
103 PSTN-1 Port Settings
001 Select Line
002 PSTN Access Number Enter the PSTN access number for the
003 Memory Lock
Disabled
004 Transmission
Disabled
104 PSTN-2 Port Settings
001 Select Line
002 PSTN Access Number Enter the PSTN access number for the G3-
003 Memory Lock
Disabled
004 Transmission
Disabled
106 ISDN Port Settings
001 Select Line
002 PSTN Access Number Enter the PSTN access number for ISDN
003 Memory Lock
Disabled
004 Transmission
Disabled
SM
SERVICE PROGRAM MODE
Function
NCU parameter settings for the standard
G3 board. Section 3.3 NCU Parameters
NCU parameter settings for the optional G3
board. Section 3.3 NCU Parameters
Function
Enter the fax number of the service station.
Select the line type.
Enter the fax unit's serial number.
Select the line type setting for the G3-1 line.
If the machine is installed on a PABX line,
select "PABX", "PABX(GND)" or
"PABX(FLASH)".
G3-1 line.
If the customer does not want to receive
transmissions using Memory Lock on this
line, turn this SP on.
If you turn this SP on, the machine does not
send any fax messages on the G3-1 line.
Select the line setting for the G3-2 (optional
extra G3) line. If the machine is installed on
a PABX line, select "PABX", "PABX(GND)"
or "PABX(FLASH)".
2 line.
If the customer does not want to receive
transmissions using Memory Lock on this
line, change this SP to on.
If you turn this SP on, the machine does not
send any fax messages on the G3-2 line.
Select the line setting for the ISDN line. If
the machine is installed on a PABX line,
select "PABX".
line.
If the customer does not want to receive
transmissions using Memory Lock on this
line, change this SP to on
If you turn this SP on, the machine does not
send any fax messages on the ISDN line.
3-5 G307