Gestetner G060 Service Manual page 429

Docking the Rack and Printer Mainframe
NOTE: If the Finisher is going to be
installed, the mounting bracket
of the rail should be attached
after docking the mainframe
with the rack. In addition, the
Finisher should be attached
after docking is complete.
1. Remove the paper tray and front
stand [A] from the paper feed unit as
shown ( x 2).
2. Remove the brackets [B] and rear
stand [C] ( x 1 for each).
3. Reinsert the paper tray.
NOTE: Since the front and rear
stands will no longer be
necessary, dispose of them
according to local
regulations.
4. Place the assembled rack down in
the area where the mainframe is to
be installed.
5. Adjust the height of the side stand
legs for stabilization if necessary.
CAUTION: The stand is designed to support objects placed on the table only after
the rack and mainframe have been docked. Therefore, use caution in
handling the assembled stand before docking, as it is relatively
unstable.
SM
MACHINE INSTALLATION
[A]
[B]
1-11
G570I201.WMF
[B]
[C]
G570I202.WMF
G570