Dip Switches; Controller Board - Gestetner G060 Service Manual

DIP SWITCHES

5.7 DIP SWITCHES

Controller Board

DIP SW No.
1
2 to 4
NOTE: If a download attempt failed, you must boot up the machine from the IC
card. To do this, DIP SW 1 on the controller board needs to be ON.
⇒
BCU Board
DIP SW No.
1 to 3
4
NOTE: A DIP switch has been added to the BCU board (P/N G0775069 or later).
This setting is very important. If the switch is not set correctly, a paper jam
or fusing problem will occur.
G060
OFF
Boot-up from flash ROM
Factory Use Only: Keep these switches OFF.
OFF
Factory Use Only: Keep these switches OFF.
Fusing clutch is not
installed
ON
Boot-up from IC card
ON
Fusing clutch is installed
5-60
Rev. 01/2003
SM