Fax Unit Options - Gestetner G060 Service Manual

1.2 FAX UNIT OPTIONS

1.2.1 G3 INTERFACE UNIT INSTALLATION
[G]

CAUTION
Before installing this option, do the following:
1. Print out all data in the printer buffer.
2. Turn off the main switch and disconnect the power cord and the
network.
1. Remove the jack window (LINE2) [A] from the panel plate [B].
2. Install the G3 board [C] and NCU board [D] (3 screws each).
3. Attach the harness clamp [E].
4. Connect the harness [F] to the connectors on G3 and NCU boards (harness
clamp [E]).
5. Connect the flat cable [G] to the connector [H] on the FCU board.
6. Connect the I/F board [I] to the G3 board and connect the flat cable [G] to the
I/F board.
NOTE: When installing the fax unit and G3 unit simultaneously, turn on the DIP
switch [J] on the MBU board.
SM
[F]
[C]
[I]
[J]
1-5
FAX UNIT OPTIONS
[E]
[D]
[G]
[H]
G307I511.WMF
[B]
[A]
G307