Gestetner G060 Service Manual page 481

Rev. 07/2003
⇒
III. Turn the main switch ON. After the following message is
displayed, press the button for the firmware you are updating
(Operation Panel, Engine, etc.).
IV. Pressing the Update button starts the firmware update. To indicate
the progress, bars change to asterisks one by one.
V. After the firmware update is completed, "Update done" or "Power
Off On" will be displayed. Turn OFF the main switch and remove
the IC card.
Start key status indication
• When the above message disappears, the Start key will blink red. This
indicates that the machine has started the firmware update. The total time
for the update is approximately 5 minutes.
• When the firmware update is completed, the Start key will blink green.
10. If updating any other firmware, repeat the procedure from Step 8.
This completes the G367 to G570 modification.
SM
PCcard -> ROM Page01
ROM:G0775611C
Engine (1)
ROM:RB1.10:23
Exit (0)
- Engine - Scanner IPU
- Music - OpePanel.DOM
- Onboard Sys - Opt DIMM Fax
- Network Support
PCcard -> ROM Page01
ROM:G0775611C
Engine (1)
ROM:RB1.10:23
Verify(./*) Exit(0)
PCcard -> ROM Page01
Update done.
Engine Card No.:1/1
3-33
NEW:G0775611F
NEW:RB111C:23
New Version (IC Card)
Current Version
NEW:G0775611F
NEW:RB111C:23
UpDate(0)
OTHERS
G570