BULLETIN NUMBER:
BULLETIN NUMBER:
BULLETIN NUMBER:
BULLETIN NUMBER:
APPLICABLE MODEL: : : :
APPLICABLE MODEL
APPLICABLE MODEL
APPLICABLE MODEL
GESTETNER – DSC38
GESTETNER – DSC38
GESTETNER – DSC38
GESTETNER – DSC38
RICOH – AP3800C
RICOH – AP3800C
RICOH – AP3800C
RICOH – AP3800C
SAVIN – SLP38C
SAVIN – SLP38C
SAVIN – SLP38C
SAVIN – SLP38C
SUBJECT:
MACHINE DOES NOT DISPLAY READY
SYMPTOM:
If the machine enters "Energy Saver 1 Mode" and cools down for more than 1 minute, when recovery warm-
up occurs, the machine does not display "Ready". The symptom occurs only when all of the following
conditions are met:
1. The machine has the fusing clutch installed.
2. The main engine firmware is version B1.15E.
3. Energy Saver 1 Mode is set to ON; (Printer default: OFF, with CF expander installed: ON).
4. The user operates the machine (after more than 1 minute) in the following manner:
• Pressing the Energy Saver Key
• Opening and closing the platen cover
• Placing an original in the ARDF
• Sending a print job
NOTE:
This does not occur when the machine is turned OFF/ON or opening and closing any covers,
except the ARDF top cover.
CAUSE:
The conditions for "Energy Saver Mode" recovery warm-up were changed when the fusing clutch
modification was applied, as a result the 120V/60Hz machine does not have enough power to reach the
temperature required to trigger the "Ready" display.
Copyright
2002 RICOH Corporation. All rights reserved.
TECHNICAL SERVICE BULLETIN
TECHNICAL SERVICE BULLETIN
TECHNICAL SERVICE BULLETIN
TECHNICAL SERVICE BULLETIN
G060 - 006
G060 -
006
G060 -
G060 -
006
006
03/20/2002
03/20/2002
03/20/2002
03/20/2002
Continued...
CONTROL NO. 075CLR