Gestetner G060 Service Manual page 910

BULLETIN NUMBER:
APPLICABLE MODEL:
GESTETNER – DSc38/DSc38S
RICOH – AP3800C/AP3800CMF
SAVIN – SLP38c/SLP38cS
SUBJECT: PAPER JAM AT REGISTRATION AREA
SYMPTOM:
Registration jams may occur during multi-print duplex jobs, which are then logged in the following SP modes.
CAUSE:
The electrical resistance of the Sheet (#G0602632) attached to the Guide Plate – Middle Registration is out
of specification in some machines from July to September '01 production. This may cause the static
electricity generated during a multi-print run to charge the Sheet, leading to a jam at the registration area
(occasionally a Z-jam).
NOTE:
The Sheet cannot be replaced individually in the field, since it is fixed to another sheet of Mylar. A
new part, called the Guide Plate – Middle Registration (#G0602613) has been newly registered as
an assembly to replace the three individual parts shown below (Guide Plate, Sheet and Guide)..
This was done because accurate replacement of the Sheet for lower registration in the field is very
difficult. Therefore when one of these three parts needs replacement in the field, please replace all
of them with the new (assembled) Guide Plate – Middle Registration.
OLD PART NO. NEW PART NO.
G0602614
G0602615
G0602632
*
DENOTES NEW ITEM NUMBER

Copyright 2002 RICOH Corporation. All rights reserved.
TECHNICAL SERVICE BULLETIN
G060/G570 - 010
SP7-504-8
SP7-504-61
GuidePlate - Middle Registration
Guide - Lower Registration
Sheet - Lower Registration
G0602613 GuidePlate - Middle Registration
Regist.: ON.
Regist.: OFF
*30
DESCRIPTION
09/18/2002
#G0602613
REFERENCE
QTY INT PAGE ITEM
1 - 0 23 15
1 - 0 23 16
1 - 0 23 14
0 - 1 1 23 *30
Continued...