Gestetner G060 Service Manual page 303

Stapling
Stapling is available when the two-tray finisher is installed.
The finisher has the following stapling positions.
Paper Feed Direction
• Depending on the paper orientation, the image may have to be rotated. The
driver rotates the image. If the paper cannot be physically stapled as specified by
the driver, it will not be stapled.
• There is a limit for the number of sheets which can be stapled. If a job has more
than this number, it will not be stapled.
For A3, 11" x 17", 8½" x 14" paper: 30 sheets
For 8½" x 11", A4, B5 paper: 50 sheets
Punching
Punching is available only when the punch kit is installed with the two-tray finisher.
The number of holes (2, 3, or 4 holes) depends on the type of punch kit.
• There is only one punch position available, so the relationship between the
punching position and the printed image depends on the paper feed orientation
and image rotation.
Paper Feed Direction
SM
2 Tray Finisher
(Printed side)
2 Tray Finisher
(Printed side)
6-73
CONTROLLER
Stapled 2 places
G060D557.WMF
Punching Position
G060D558.WMF
G060